Zmorph 2.0 S - Setting Gcodes

SOFTWARE / BASICS
34
SETTING GCODES
Print speed: 40 mm/s (normal quality)
Layer height when using 0.4mm nozzle: 0.25mm
First layer height when using 0.4mm nozzle: 0.3mm
Nozzle temperature for ABS: 225-245°C
Nozzle temperature for PLA: 185-200°C
Bed temperature for ABS: 100-110°C
Bed temperature for PLA: 60-70°C
Inll ratio: 0.4, inll type: 40%
Inll ratio for large objects: 10%, inll type: honeycomb
Inll ratio for strong solid objects: 60%, inll type: rectilinear
Recommendations for G-code generation for ZMorph personal fabricator: