MAINTENANCE AND FUNCTION / TROUBLESHOOTING AND ADJUSTMENTS
76
DESIGN YOUR OWN TOOLHEADS
If you’re experienced enough to create and build your own toolhead,
please read information here:
http://zmorph3d.com/custom-toolhead/
If you want to design your own toolhead, check specications of the mount and wiring at:
www.zmorph3d.com
You can download CAD les, technical drawings and working examples.
Two stepper motor drivers, able to drive up to 2A per motor
(typically NEMA17, but you can also try bigger motors)
Two high-power 24V outputs (typically used for heaters)
Three smaller-power 24V outputs (typically used for fans, lighting etc)
Two sensor inputs (typically used for thermistors)
For your disposal you will have:
To Next Page
Loading...
