MAINTENANCE AND FUNCTION / TOOLHEADS
54
LUBRICATION
EXCHANGE AND REPLACEMENT OF EXTRUDER
It is not recommended to use oil to lubricate smooth rods - sliding bearings
don’t require anything to run. Only if you’re experiencing high friction, it is acceptable,
but needs to be cleaned from time to time, due to high temperatures inside.
ZMorph allows exchange of dierent toolheads and accessories:
• EXTRUDERS
• DREMELS
• OTHER EXPERIMENTAL MODULES
(LIKE LASERS)
However - It might be helpful to lubricate Z axis trapezoidal screws.
If you experience high friction on Y axis (linear rails for heated bed),
they should be cleaned with water and soap or WD40 uid.
Exchange is done by unscrewing one mounting screw in front, and unplugging
mounting cable.
1
Important:To unplug the extruder/toolhead ALWAYS switch o the power.
If you do not - you’re risking damaging your electronics.
!
plugs on le and right for connecting dierent extruders
Instruction video can be seen here: https://vimeo.com/119830882
To Next Page
Loading...
