Zmorph 2.0 S - Chamber

OVERVIEW / THE ZMORPH
8
1
CHAMBER
Zmorph has two covers that creates a closed heat chamber. This enables the machine to print
in ABS, which otherwhise would crack and warp due to uneven temperature.
The covers add extra safety when the machine is running, which is desirable for educational
use and public exhibitions. Fumes and noise are also kept inside.
When you work around the machine you might want to keep the covers open.
There is a magnetic lock built into the hinges. Just li the cover up until you hear click,
and you can leave it in this position.
In warmer days PLA prints come our better if the cover is lied.Cooling is more eicient in such
conditions. To achieve the same result with closed chamber, decrease extrusion temperature.