SOFTWARE / VOXELIZER
38
3D printer creates objects by placing layers starting from bottom to top of the model.
For this reason every overhanging model part needs support material.
To generate commands for printer it’s important to set appropriate head speeds.
If you don’t know what to set you should use standard values.
You can now be a bit overwhelmed by number of possibilities and settings but don’t
worry, it only looks complicated. Try printing rst few objects using standard values,
once you get more experience, you can start tweaking them and experimenting on your own.
In support settings you will nd
settins connected with support parts.
To enable support click 'generate sup-
port' button. Voxelizer will create new
Voxel object acting as support.
In eld „support angle” you can set
minimum angle of surface which needs
support. To change the way support
prints (density, inll) edit support TAB.
2
Great!
You’ve prepared your rst print.
Now click GENERATE GCODE button.
3
To Next Page
Loading...
Need help?
General
