OVERVIEW / THE ZMORPH
5
The machine shall not be covered during operation.
The machine must be supervised at all times.
ZMorph extruders and toolheads should be used only with materials
they were designed for.
Other use is prohibited and will void warranty.
The machine must be positioned on at surface.
During operation, the machine will produce high temperatures.
The user should not touch any elements marked with "hot surface" sticker.
Aer nishing working, the machine should be stored in a dry and clean area.
Filaments for 3D printing should be stored in clean and dry place.
The use of dirty laments might cause nozzle blockage.
The machine might emit fumes.
Make sure You work in a well ventilated environment.
If fumes make You feel unwell, switch the machine o and allow fresh air in.
!
!
!
!
!
!
!
!
To Next Page
Loading...
