Capturing audio before recording starts (pre-recording)
The input signal is always buffered for a set amount of time, so it can be captured (pre-recorded) for up to 6
seconds before the time when the (REC) button is operated to start recording.
This is useful when the (REC) button is operated late, for example.
1. On the Home Screen, use the (selection) dial to select (REC) and press the
(ENTER) button.
This opens the Rec Settings Screen.
2. Use the (selection) dial to select “Pre Rec” and press the (ENTER) button to confirm.
3. Use the (selection) dial to select “On” and press the (ENTER) button to confirm.
The amount of time that can be pre-recorded when this is set to “On” depends on the sample rate
setting (→Setting the sample rate).
Sample rate Pre-recording time
44.1 kHz 6 seconds
48 kHz 6 seconds
96 kHz 3 seconds
192 kHz 1 second
78
To Next Page
Loading...
