Enabling the recording start tone
Half-second tone signals (recording start tones) can be output from the output jacks (headphone and LINE
OUT jacks) when recording is started.
Since recording start tones are also written to recording files, when recording audio for video with the
H5studio, sending its output signal to the camera input can make synchronizing audio and video easier.
1. On the Home Screen, use the (selection) dial to select (REC) and press the
(ENTER) button.
This opens the Rec Settings Screen.
2. Use the (selection) dial to select “Rec Start Tone” and press the (ENTER) button to
confirm.
3. Use the (selection) dial to select the recording start tone level and press the (ENTER)
button to confirm.
The following levels can be selected.
Off, –40 dBFS, –20 dBFS, –12 dBFS, –6 dBFS
No recording start tone will be played if “OFF” is selected.
79
To Next Page
Loading...
