Chapter 17 Link Aggregation
ES-2024 Series User’s Guide
140
17.4 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting
to display the screen shown next. See Section 17.1 on page 137 for more
information on link aggregation.
Figure 67 Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 36 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Link
Aggregation
Setting
This is the only screen you need to configure to enable static link
aggregation.
Group ID The field identifies the link aggregation group, that is, one logical link
containing multiple ports.
Active Select this option to activate a trunk group.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
