ZyXEL Communications ES-2024 Series - Port Setup

Chapter 8 Basic Setting
ES-2024 Series User’s Guide
81
8.7 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting > Port
Setup in the navigation panel to display the configuration screen.
Figure 36 Basic Setting > Port Setup
The following table describes the labels in this screen.
Default
Gateway
This field displays the IP address of default gateway.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 10 Basic Setting > IP Setup (continued)
LABEL DESCRIPTION
Table 11 Basic Setting > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to enable a port. The factory default for all ports is
enabled. A port must be enabled for data transmission to occur.