ZyXEL Communications ES-2024 Series - SNMP Traps

Chapter 29 Access Control
ES-2024 Series User’s Guide
236
29.3.3 SNMP Traps
The Switch sends traps to an SNMP manager when an event occurs. The following
tables outline the SNMP traps by category.
An OID (Object ID) that begins with “1.3.6.1.4.1.890.1.5.8.16” (ES-2024A) or
“1.3.6.1.4.1.890.1.5.8.27” (ES-2024PWR) is defined in private MIBs. Otherwise,
it is a standard MIB OID.
Table 79 SNMP System Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
coldstart coldStart 1.3.6.1.6.3.1.1.5.1 This trap is sent when the
Switch is turned on.
warmstart warmStart 1.3.6.1.6.3.1.1.5.2 This trap is sent when the
Switch restarts.
fanspeed FanSpeedEventOn 1.3.6.1.4.1.890.1.5.8.16.2
7.2.1
This trap is sent when the fan
speed goes above or below the
normal operating range.
FanSpeedEventClear 1.3.6.1.4.1.890.1.5.8.27.2
7.2.2
This trap is sent when the fan
speed returns to the normal
operating range.
temperatu
re
TemperatureEventOn 1.3.6.1.4.1.890.1.5.8.16.2
7.2.1
This trap is sent when the
temperature goes above or
below the normal operating
range.
TemperatureEventClear 1.3.6.1.4.1.890.1.5.8.27.2
7.2.2
This trap is sent when the
temperature returns to the
normal operating range.
voltage VoltageEventOn 1.3.6.1.4.1.890.1.5.8.27.2
7.2.1
This trap is sent when the
voltage goes above or below the
normal operating range.
VoltageEventClear 1.3.6.1.4.1.890.1.5.8.27.2
7.2.2
This trap is sent when the
voltage returns to the normal
operating range.
reset UncontrolledResetEventO
n
1.3.6.1.4.1.890.1.5.8.16.2
7.2.1
1.3.6.1.4.1.890.1.5.8.27.2
7.2.1
This trap is sent when the
Switch automatically resets.
ControlledResetEventOn 1.3.6.1.4.1.890.1.5.8.16.2
7.2.1
1.3.6.1.4.1.890.1.5.8.27.2
7.2.1
This trap is sent when the
Switch resets by an
administrator through a
management interface.
RebootEvent 1.3.6.1.4.1.890.1.5.1.1.2 This trap is sent when the
Switch reboots by an
administrator through a
management interface.