Chapter 29 Access Control
ES-2024 Series User’s Guide
243
29.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the
Trap Group screen to specify the types of SNMP traps that should be sent to each
SNMP manager.
Figure 129 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 85 Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap
Destination IP
Select one of your configured trap destination IP addresses. These are
the IP addresses of the SNMP managers. You must first configure a trap
destination IP address in the SNMP Setting screen.
Use the rest of the screen to select which traps the Switch sends to that
SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the
SNMP manager.
Options Select the individual SNMP traps that the Switch is to send to the SNMP
station. See Section 29.3.3 on page 236 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically
selects all of the category’s traps. Clear the check boxes for individual
traps that you do not want the Switch to send to the SNMP station.
Clearing a category’s check box automatically clears all of the category’s
trap check boxes (the Switch only sends traps from selected categories).
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
