Chapter 28 Maintenance
ES-2024 Series User’s Guide
227
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
28.4 Reboot System
Reboot System allows you to restart the Switch without physically turning the
power off. The Switch loads configuration one (Config 1) when you reboot. Follow
the steps below to reboot the Switch.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to
reboot and load configuration one. The following screen displays.
Figure 122 Reboot System: Confirmation
2 Click OK again and then wait for the Switch to restart. This takes up to two
minutes. This does not affect the Switch’s configuration.
28.5 Firmware Upgrade
Make sure you have downloaded (and unzipped) the correct model firmware and
version to your computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the
wrong model firmware may damage your device.
From the Maintenance screen, display the Firmware Upgrade screen as shown
next.
Figure 123 Management > Maintenance > Firmware Upgrade
To Next Page
Loading...
