ZyXEL Communications ES-2024 Series - ARP Inspection VLAN Configure

Chapter 23 IP Source Guard
ES-2024 Series User’s Guide
198
23.5.2 ARP Inspection VLAN Configure
Use this screen to enable ARP inspection on each VLAN and to specify when the
Switch generates log messages for receiving ARP packets from each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Configure > VLAN.
Figure 101 ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Table 64 ARP Inspection VLAN Configure
LABEL DESCRIPTION
VLAN Use this section to specify the VLANs you want to manage in the
section below.
Start VID Enter the lowest VLAN ID you want to manage in the section
below.
End VID Enter the highest VLAN ID you want to manage in the section
below.
Apply Click this to display the specified range of VLANs in the section
below.
VID This field displays the VLAN ID of each VLAN in the range
specified above. If you configure the * VLAN, the settings are
applied to all VLANs.
Enabled Select Yes to enable ARP inspection on the VLAN. Select No to
disable ARP inspection on the VLAN.