Chapter 24 Loop Guard
ES-2024 Series User’s Guide
203
port N. The Switch will shut down port N if it detects that the probe packet has
returned to the Switch.
Figure 105 Loop Guard - Network Loop
Note: After resolving the loop problem on your network you can re-activate the
disabled port (see Section 8.7 on page 81).
24.2 Loop Guard Setup
Click Advanced Application > Loop Guard in the navigation panel to display the
screen as shown.
Note: The loop guard feature can not be enabled on the ports that have Spanning
Tree Protocol (RSTP or MSTP) enabled.
Figure 106 Advanced Application > Loop Guard
To Next Page
Loading...
