Chapter 17 Link Aggregation
ES-2024 Series User’s Guide
143
1 Make your physical connections - make sure that the ports that you want to
belong to the trunk group are connected to the same destination. The following
figure shows ports 2-5 on switch A connected to switch B.
Figure 69 Trunking Example - Physical Connections
2 Configure static trunking - Click Advanced Application > Link Aggregation
> Link Aggregation Setting. In this screen activate trunking group T1 and
select the ports that should belong to this group as shown in the figure below.
Click Apply when you are done.
Figure 70 Trunking Example - Configuration Screen
Your trunk group 1 (T1) configuration is now complete; you do not need to go to
any additional screens.
To Next Page
Loading...
