NBG4604 User’s Guide
159
CHAPTER 17
Remote Management
17.1 Overview
This chapter provides information on the Remote Management screens.
Remote management allows you to determine which services/protocols can access
which NBG4604 interface (if any) from which computers.
You may manage your NBG4604 from a remote location via:
Note: When you configure remote management to allow management from the LAN
and WAN in the options above, you still need to configure a firewall rule to allow
access. See the firewall chapters for details on configuring firewall rules.
Note: The Remote MGMT screens are accessible to the supervisor level account
only.
Note: The Remote MGMT screens should be configured with Access Control Rule
(Section 13.5 on page 137) for applying remote management from WAN/
Internet.
17.2 What You Can Do
Use the WWW screen (Section 17.4 on page 161) to change your NBG4604’s
World Wide Web settings.
•Use the Telnet screen (Section 17.5 on page 162) to configure through which
interface(s) and from which IP address(es) users can use Telnet to manage the
NBG4604.
•Use the FTP screen (Section 17.6 on page 162) to configure through which
interface(s) and from which IP address(es) users can use FTP to access the
NBG4604.
• Your NBG4604 can act as an SNMP agent, which allows a manager station to
manage and monitor the NBG4604 through the network. Use the SNMP screen
(see Section 17.7 on page 163) to configure SNMP settings. You can also specify
from which IP addresses the access can come.
•LAN only •LAN and WAN
To Next Page
Loading...
