NBG4604 User’s Guide
209
CHAPTER 25
Product Specifications
The following tables summarize the NBG4604’s hardware and firmware features.
Table 74 Hardware Features
Dimensions (W x D x
H)
140 mm x 110 mm x 30 mm
Weight 190 g
Power Specification Input: 100-240 AC, 50/60 Hz
Output: 12 V DC 1A
Ethernet ports Auto-negotiating: 10/100/1000 Mbps in either half-duplex or full-
duplex mode.
Auto-crossover: Use either crossover or straight-through Ethernet
cables.
4-5 Port Switch A combination of switch and router makes your NBG4604 a cost-
effective and viable network solution. You can add up to four
computers to the NBG4604 without the cost of a hub when
connecting to the Internet through the WAN port. You can add up
to five computers to the NBG4604 when you connect to the
Internet in AP mode. Add more than four computers to your LAN
by using a hub.
LEDs PWR, LAN1-4, WAN, WLAN, WPS
Reset Button The reset button is built into the rear panel. Use this button to
restore the NBG4604 to its factory default settings. Press for 1
second to restart the device. Press for 5 seconds to restore to
factory default settings.
WPS button Press the WPS on two WPS enabled devices within 120 seconds
for a security-enabled wireless connection.
Antenna The NBG4604 is equipped with a 2dBi (2.4GHz) detachable
antenna to provide clear radio transmission and reception on the
wireless network.
Operation
Environment
Temperature: 0º C ~ 40º C / 32ºF ~ 104ºF
Humidity: 20% ~ 90%
Storage Environment Temperature: -30º C ~ 70º C / -22ºF ~ 158ºF
Humidity: 20% ~ 95%
To Next Page
Loading...
