Chapter 9 LAN
NBG4604 User’s Guide
115
9.4 LAN IP Screen
Use this screen to change your basic LAN settings. Click Network > LAN.
Figure 66 Network > LAN > IP
The following table describes the labels in this screen.
Table 42 Network > LAN > IP
LABEL DESCRIPTION
Get from DHCP
Server
Select this to have your NBG4604 receive its IP address automatically
from a DHCP server.
User Defined LAN
IP
Select this to manually enter the IP address and Subnet Mask as they
were provided to you by your network administrator.
IP Address Type the IP address of your NBG4604 in dotted decimal notation
192.168.1.1 (factory default).
IP Subnet
Mask
The subnet mask specifies the network number portion of an IP
address. Your NBG4604 will automatically calculate the subnet mask
based on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the NBG4604.
Apply Click Apply to save your changes back to the NBG4604.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
