Chapter 17 Remote Management
NBG4604 User’s Guide
166
17.8 The ACS Screen
An administrator can use an ACS to remotely set up the NBG4604, modify its
settings, perform firmware upgrades, and monitor and diagnose it. In order to do
so, you must enable the TR-069 feature on your NBG4604 and then configure it
appropriately. (The ACS server which it will use must also be configured by its
administrator.)
The following terms and concepts may help as you read this part.
ACS
An Auto-Configuration Server (ACS) centralizes the management and
configuration of a variety of networking devices such as routers, set-top boxes,
Voice over IP (VoIP) gateways, and other Customer Premises Equipment (CPE). It
is based on the TR-069 standard.
OUI Filter
An Organizationally Unique Identifier (OUI) filter blocks or forwards packets from
devices with the specified OUI in the MAC address. The OUI field is the first three
SNMP Settings
Enable SNMP Select this to enable SNMP on this device.
SNMP version Select the SNMP version that corresponds the SNMP used by the server.
Read
Community
Enter the SNMP read community information here.
Set
Community
Enter the SNMP get community information here.
System
Location
Enter the SNMP system location.
System
Contact
Enter the SNMP system contact.
Trap Settings
Trap Settings Select this to enable trap settings on this device.
Trap Manager
IP
Type the IP address of the station to send your SNMP traps to.
Trap
Community
Type the trap community, which is the password sent with each trap to
the SNMP manager. The default is public and allows all requests.
Apply Click Apply to save the setting to the NBG4604.
Cancel Click Reset to begin configuring this screen afresh.
Table 64 Management > Remote MGMT > SNMP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
