Chapter 17 Remote Management
NBG4604 User’s Guide
160
•Use the ACS screen (Section 17.8 on page 166) to configure set up the ACS
server information on your NBG4604.
17.3 What You Need To Know
To disable remote management of a service, select Disable in the corresponding
Server Access field. You may only have one remote management session
running at a time.
17.3.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1 You have disabled that service in one of the remote management screens.
2 The IP address in the Secured Client IP Address field does not match the client
IP address. If it does not match, the NBG4604 will disconnect the session
immediately.
3 There is already another remote management session with an equal or higher
priority running. You may only have one remote management session running at
one time.
4 There is a firewall rule that blocks it.
17.3.2 Remote Management and NAT
When NAT is enabled:
• Use the NBG4604’s WAN IP address when configuring from the WAN.
• Use the NBG4604’s LAN IP address when configuring from the LAN.
17.3.3 System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The NBG4604 automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling. You can change the timeout
period in the System screen
To Next Page
Loading...
