ZyXEL Communications NBG4604 - Configuring Your Settings; LAN Settings; WLAN and Maintenance Settings

Chapter 5 AP Mode
NBG4604 User’s Guide
60
5.4 Configuring Your Settings
Use this section to configure your NBG4604 settings while in AP Mode.
5.4.1 LAN Settings
Click Network > LAN to see the screen below.
Note: If you change the IP address of the NBG4604 in the screen below, you will need
to log into the NBG4604 again using the new IP address.
Figure 28 Network > LAN > IP
The table below describes the labels in the screen.
Table 21 Network > LAN > IP
5.4.2 WLAN and Maintenance Settings
The configuration of wireless and maintenance settings in AP Mode is the same as
for Router Mode.
• See Chapter 5 on page 69 for information on the configuring your wireless
network.
LABEL DESCRIPTION
Get from
DHCP Server
Select this to let the DHCP server in the gateway assign the NBG4604 IP
address.
User Defined
LAN IP
Select this to give the NBG4604 a static IP address.
IP Address Type the IP address in dotted decimal notatiion. The default setting is
192.168.1.2. If you change the IP address you will have to log in again
with the new IP address.
IP Subnet
Mask
The subnet mask specifies the network number portion of an IP address.
Your NBG4604 will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the NBG4604.
Apply Click Apply to save your changes to the NBG4604.
Reset Click Reset to reload the previous configuration for this screen.