Chapter 17 Remote Management
NBG4604 User’s Guide
161
17.4 WWW Screen
To change your NBG4604’s World Wide Web settings, click Management >
Remote MGMT to display the WWW screen.
Figure 89 Management > Remote MGMT > WWW
The following table describes the labels in this screen
Table 61 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Server Access Select the interface(s) through which a computer may access the
NBG4604 using this service.
Secured Client
IP Address
A secured client is a “trusted” computer that is allowed to communicate
with the NBG4604 using this service.
Select All to allow any computer to access the NBG4604 using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the NBG4604 using this service.
Note: This only applies on WAN IP.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
