Chapter 21 Tools
NBG4604 User’s Guide
193
21.4.2 Restore Configuration
Restore configuration allows you to upload a new or previously saved
configuration file from your computer to your NBG4604.
Note: Do not turn off the NBG4604 while configuration file upload is in progress
After you see a “configuration upload successful” screen, you must then wait one
minute before logging into the NBG4604 again.
Figure 116 Configuration Restore Successful
The NBG4604 automatically restarts in this time causing a temporary network
disconnect. In some operating systems, you may see the following icon on your
desktop.
Figure 117 Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default
NBG4604 IP address (192.168.1.1). See Appendix C on page 231 for details on
how to set up your computer’s IP address.
Table 72 Maintenance Restore Configuration
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click
Browse... to find it.
Browse... Click Browse... to find the file you want to upload. Remember that you
must decompress compressed (.ZIP) files before you can upload them.
Upload Click Upload to begin the upload process.
To Next Page
Loading...
