ZyXEL Communications NBG4604 - No Security

Chapter 7 Wireless LAN
NBG4604 User’s Guide
83
See the rest of this chapter for information on the other labels in this screen.
7.4.1 No Security
Select No Security to allow wireless stations to communicate with the access
points without any data encryption.
Note: If you do not enable any wireless security on your NBG4604, your network is
accessible to any wireless networking device that is within range.
Figure 44 Network > Wireless LAN > General: No Security
Security
Mode
Select No Security, Static WEP, WPA-PSK, or WPA2-PSK to add
security on this wireless network. The wireless clients which want to
associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears
in this screen. See 7.4.2 and 7.4.3 sections. Or you can select No
Security to allow any client to associate this network without
authentication.
Note: If you enable the WPS function, only No Security, WPA-PSK
and WPA2-PSK are available in this field.
Apply Click Apply to save your changes back to the NBG4604.
Reset Click Reset to reload the previous configuration for this screen.
Table 24 Network > Wireless LAN > General
LABEL DESCRIPTION