ZyXEL Communications NBG4604 - 13.4 General Firewall Screen; 13.5 The Access Control Rule Screen

Chapter 13 Firewall
NBG4604 User’s Guide
137
13.4 General Firewall Screen
Use this screen to enable or disable the NBG4604’s firewall, and set up firewall
logs. Click Security > Firewall to open the General screen.
Figure 77 Security > Firewall > General
The following table describes the labels in this screen.
13.5 The Access Control Rule Screen
Click Firewall > Access Control Rule to display the following screen. This
screen displays a list of the configured access control rules.
Figure 78 Firewall > Access Control Rule
Table 50 Security > Firewall > General
LABEL DESCRIPTION
Enable Firewall Select this check box to activate the firewall. The NBG4604 performs
access control and protects against Denial of Service (DoS) attacks
when the firewall is activated.
Apply Click Apply to save the settings.
Reset Click Reset to start configuring this screen again.