Chapter 7 Wireless LAN
NBG4604 User’s Guide
97
Click Network > Wireless LAN > WDS tab. The following screen opens with the
Basic Setting set to Disabled, and Security Mode set to No Security.
Figure 54 Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 35 Network > Wireless LAN > WDS
LABEL DESCRIPTION
WDS Setup
Basic Settings Select the operating mode for your NBG4604.
• AP + Bridge -
The NBG4604 functions as a bridge and access point
simultaneously.
• Bridge - The NBG4604 acts as a wireless network bridge and
establishes wireless links with other APs. You need to know the MAC
address of the peer device, which also must be in bridge mode. The
NBG4604 can establish up to five wireless links with other APs.
Select Disable if you do not want to use this feature.
Local MAC
Address
This is the MAC address of your NBG4604.
Phy Mode Select a WDS physical layer transceiver mode.
Remote MAC
Address
This is the MAC address of the peer device that your NBG4604 wants to
make a bridge connection with.
You can connect to up to 4 peer devices.
Security
Security Mode
Note: WDS security is independent of the security settings
between the NBG4604 and any wireless clients.
The WDS is set to No Security by default.
• Refer to Section 7.11.1 on page 98 to view the screen for Static
WEP security.
• Refer to Section 7.11.2 on page 99 to view the screen for WPA2-
PSK security.
Apply Click Apply to save your changes to NBG4604.
Refresh Click Refresh to reload the previous configuration for this screen.
To Next Page
Loading...
