Chapter 9 Device Management
NR2301 User’s Guide
91
Figure 57 APP MODULE > Configuration Backup
The following table describes the labels in this screen.
Note: If you uploaded the default configuration file you may need to change the IP address
of your computer to be in the same subnet as that of the default NR2301 IP address
(192.168.1.1).
9.10 Device Reboot
Use the Device Reboot screen to restart the NR2301. You can also set a schedule to reboot the NR2301.
System restart allows you to reboot the NR2301 without turning the power off. Click Restart to reboot the
Table 45 APP MODULE > Configuration Backup
LABEL DESCRIPTION
Configuration
File
Click Backup to save the NR2301’s current configuration file with a “.bin” extension to your
computer.
Configuration Restore
Select File Click Select File to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Note: Do not turn off the NR2301 while configuration file upload is in progress.
The NR2301 automatically restarts in this time causing a temporary network disconnect.
Factory Default
Settings
Press this button to clear all user-entered configuration information and returns the NR2301 to its
factory defaults.
You can also press the RESET button on the side panel to reset the factory defaults of your
NR2301. Refer to the chapter about introducing the Web Configurator for more information on
the RESET button. See Section 1.4.3 on page 11.
Return Click this button to return to the APP MODULE list.
To Next Page
Loading...
