Chapter 9 Device Management
NR2301 User’s Guide
95
The following table describes the labels in this screen.
9.13 DDNS
Dynamic Domain Name Service (DDNS) services let you use a fixed domain name with a dynamic IP
address. Users can always use the same domain name instead of a different dynamic IP address that
changes each time to connect to the NR2301 or a server in your network.
Note: The NR2301 must have a public global IP address and you should have your registered
DDNS account information on hand.
To change your NR2301’s DDNS, click APP MODULE > DDNS. The screen appears as shown.
Table 47 APP MODULE > WPS
LABEL DESCRIPTION
WPS Turn the switch button on to enable WPS on the NR2301.
Apply Click Apply to save your changes back to the NR2301.
PCB Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Click
Start and add another WPS-enabled wireless device (within wireless range of the NR2301) to
your wireless network. This button may either be a physical button on the outside of device, or a
menu button similar to the WPS button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of
pressing this button.
PIN Use this section to set up a WPS wireless network by using the PIN of the client. Enter the PIN of
the device that you are setting up a WPS connection with and click Start to authenticate and
add the wireless device to your wireless network.
You can find the PIN by checking the device’s settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the NR2301.
Return Click this button to return to the APP MODULE list.
To Next Page
Loading...
