Chapter 9 Device Management
NR2301 User’s Guide
97
Click APP MODULE > VPN Passthrough to display the following screen. Turn the switch button on to
enable L2TP, IPSEC, and PPTP. Then click Apply to save your changes back to the NR2301. Click the
Return button to return to the APP MODULE list.
Figure 62 APP MODULE > VPN Passthrough
9.15 Power Save
Use the Power Save screen to enable and configure the power saving settings in the NR2301.
Click APP MODULE > Power Save to display the following screen.
Select the number of minutes after which the NR2301 activates power saving and enters sleep mode. In
Power Saving the NR2301 turns off its WiFi connections to save battery power when the USB port is not
connected, and there are no WiFi clients associating with the NR2301. Then click Apply to save your
changes back to the NR2301. Click the Return button to return to the APP MODULE list.
Figure 63 APP MODULE > Power Save
To Next Page
Loading...
