Chapter 16 System
NWA50AX User’s Guide
142
The Zyxel Device continues to use the following pre-defined list of NTP time servers if you do not specify a
time server or it cannot synchronize with the time server you specified.
When the Zyxel Device uses the pre-defined list of NTP time servers, it randomly selects one server and
tries to synchronize with it. If the synchronization fails, then the Zyxel Device goes through the rest of the
list in order from the first one tried until either it is successful or all the pre-defined NTP time servers have
been tried.
16.3.2 Tim e Se rve r Sync hro niza tio n
Click the Sync . No w button to get the time and date from the time server you specified in the Tim e
Se rve r Addre ss field.
When the Lo a ding message appears, you may have to wait up to one minute.
Fig ure 84 Loading
The C urre nt Tim e and Curre nt Da te fields will display the appropriate settings if the synchronization is
successful.
If the synchronization was not successful, a log displays in the Vie w Lo g screen. Try re-configuring the
Da te / Tim e screen.
To manually set the Zyxel Device date and time:
1 Click Syste m > Da te / Tim e .
2 Select Ma nua l under Tim e a nd Da te Se tup .
3 Enter the Zyxel Device’s time in the Ne w Tim e field.
4 Enter the Zyxel Device’s date in the Ne w Da te field.
5 Under Tim e Zo ne Se tup, select your Tim e Zo ne from the list.
6 As an option you can select the Ena b le Da ylig ht Sa ving check box to adjust the Zyxel Device clock for
daylight savings.
7 Click Ap ply.
To get the Zyxel Device date and time from a time server:
1 Click Syste m > Da te / Tim e .
2 Select G e t fro m Tim e Se rve r under Time a nd Da te Se tup.
Table 63 Default Time Servers
0.pool.ntp.org
1.pool.ntp.org
2.pool.ntp.org
To Next Page
Loading...
