Chapter 16 System
NWA50AX User’s Guide
145
Fig ure 87 Configuration > System > WWW > Service Control
The following table describes the labels in this screen.
16.4.5 HTTPS Exa m ple
If you have not changed the default HTTPS port on the Zyxel Device, then in your browser enter “https://
Zyxel Device IP Address/” as the web site address where “Zyxel Device IP Address” is the IP address or
domain name of the Zyxel Device you wish to access.
Table 64 Configuration > System > WWW > Service Control
LABEL DESCRIPTIO N
HTTPS
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Se rvic e Co ntro l table to access the Zyxel Device Web
Configurator using secure HTTPs connections.
Server Port The HTTPS server listens on port 443 by default. If you change the HTTPS server port to a
different number on the Zyxel Device, for example 8443, then you must notify people who
need to access the Zyxel Device Web Configurator to use “https://Zyxel Device IP
Address:8443” as the URL.
Authenticate Client
Certificates
Select Authe ntic a te Clie nt C e rtific a te s (optional) to require the SSL client to authenticate
itself to the Zyxel Device by sending the Zyxel Device a certificate. To do that the SSL client
must have a CA-signed certificate from a CA that has been imported as a trusted CA on
the Zyxel Device.
Server Certificate Select a certificate the HTTPS server (the Zyxel Device) uses to authenticate itself to the
HTTPS client. You must have certificates already configured in the My Ce rtific a te s screen.
Redirect HTTP to HTTPS To allow only secure Web Configurator access, select this to redirect all HTTP connection
requests to the HTTPS server.
HTTP
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Se rvic e Co ntro l table to access the Zyxel Device Web
Configurator using HTTP connections.
Server Port You may change the server port number for a service if needed, however you must use
the same port number in order to use that service to access the Zyxel Device.
Apply Click Ap p ly to save your changes back to the Zyxel Device.
Reset Click Re se t to return the screen to its last-saved settings.
To Next Page
Loading...
