Chapter 19 Diagnostics
NWA50AX User’s Guide
179
Fig ure 108 Maintenance > Diagnostics: Debug Information Collector
19.3 Re m o te C a pture
Use this screen to capture network traffic going through the Zyxel Device connected to the Zyxel
gateway or ZyWALL, and output the captured packets to a packet analyzer (also known as network or
protocol analyzer) such as Wireshark.
Click Ma inte na nc e > Dia g no stic s> Re mo te C a pture to open the Re m o te C a pture screen.
Fig ure 109 Maintenance > Diagnostics> Remote Capture
The following table describes the labels in this screen.
Table 75 Maintenance > Diagnostics> Remote Capture
LABEL DESCRIPTIO N
Server Port Enter the number of the server port you want the packet analyzer to connect to in order to
capture traffic going through the Zyxel Device. The default port number is 2002.
Start Click this button to allow the packet analyzer to start capturing traffic going through the Zyxel
Device.
Stop Click this button to stop the packet analyzer from capturing traffic going through the Zyxel
Device.
To Next Page
Loading...
