NWA50AX User’s Guide
180
C HAPTER 20
LEDs
20.1 O ve rvie w
The LEDs of your Zyxel Device can be controlled such that they stay lit (ON) or OFF after the Zyxel Device
is ready. There are two features that control the LEDs of your Zyxel Device - Loc a tor and Suppre ssion (see
Section 1.4 on page 18).
20.1.1 Wha t Yo u C a n Do in this C ha pte r
• The Suppre ssio n screen (
Section 20.2 on page 180) allows you to set how you want the LEDs to
behave after the Zyxel Device is ready.
• The Lo c a tor screen (Section 20.3 on page 181) allows users to see the actual location of the Zyxel
Device between several devices in the network.
20.2 Suppre ssio n Sc re e n
The LED Suppression feature allows you to control how the LEDs of your Zyxel Device behave after it’s
ready. The default LED suppression setting of your AP is different depending on your Zyxel Device model.
You can go to the Ma inte na nc e > LEDs > Suppre ssio n screen to see the default LED behavior and
change the LED suppression setting. After you make changes in the suppression screen, it will be stored
as the default when the Zyxel Device is restarted. See (
Section 3.1 on page 28) for information on default
values for different models.
Note: When the ZyXEL Device is booting or performing firmware upgrade, the LEDs will light up
regardless of the setting in LED suppression.
To access this screen, click Ma inte na nc e > LEDs > Suppre ssio n.
To Next Page
Loading...
