NWA50AX User’s Guide
69
C HAPTER 9
Ne two rk
9.1 O ve rvie w
This chapter describes how you can configure the management IP address and VLAN settings of your
Zyxel Device.
The Internet Protocol (IP) address identifies a device on a network. Every networking device (including
computers, servers, routers, printers, etc.) needs an IP address to communicate across the network.
These networking devices are also known as hosts.
Fig ure 38 IP Setup
The figure above illustrates one possible setup of your Zyxel Device. The gateway IP address is 192.168.1.1
and the managed IP address of the Zyxel Device is 192.168.1.2 (default), but if the Zyxel Device is
assigned an IP address by a DHCP server, the default (192.168.1.2) will not be used. The gateway and
the Zyxel Device must belong in the same IP subnet to be able to communicate with each other.
9.1.1 Wha t Yo u C a n Do in this C ha pte r
• The IP Se tting screen (
Section 9.2 on page 69) configures the Zyxel Device’s LAN IP address.
• The VLAN screen (
Section 9.3 on page 71) configures the Zyxel Device’s VLAN settings.
• The NCC Disc o ve ry screen (
Section 9.4 on page 73) configures the Zyxel Device’s Nebula Control
Center (NCC) discovery settings.
9.2 IP Se tting
Use this screen to configure the IP address for your Zyxel Device. To access this screen, click
C o nfig ura tion > Ne two rk > IP Se tting .
To Next Page
Loading...
