Chapter 9 Network
NWA50AX User’s Guide
71
9.3 VLAN
This section discusses how to configure the Zyxel Device’s VLAN settings.
Note: Mis-configuring the management VLAN settings in your Zyxel Device can make it
inaccessible. If this happens, you will have to reset the Zyxel Device.
Fig ure 40 Management VLAN Setup
IPv6 Address/
Prefix Length
Enter the IPv6 address and the prefix length for the LAN interface if you want to use a static
IP address. This field is optional.
The prefix length indicates what the left-most part of the IP address is the same for all
computers in the network, that is, the network address.
Gateway Enter the IPv6 address of the default outgoing gateway using colon (:) hexadecimal
notation.
Metric Enter the priority of the gateway (if any) on the LAN interface. The Zyxel Device decides
which gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the Zyxel Device uses the one that was
configured first. Enter zero to set the metric to 1024 for IPv6.
DHCPv6 Client Select this option to set the Zyxel Device to act as a DHCPv6 client.
DUID This field displays the DHCP Unique IDentifier (DUID) of the Zyxel Device, which is unique and
used for identification purposes when the Zyxel Device is exchanging DHCPv6 messages
with others. See
Appendix B on page 230 for more information.
Request Address Select this option to get an IPv6 address from the DHCPv6 server.
DHCPv6 Request
Options
Select this option to determine what additional information to get from the DHCPv6 server.
DNS Server Select this option to obtain the IP address of the DNS server.
NTP Server Select this option to obtain the IP address of the NTP server.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Re se t to return the screen to its last-saved settings.
Table 25 Configuration > Network > IP Setting (continued)
LABEL DESCRIPTIO N
To Next Page
Loading...
