Chapter 18 File Manager
NWA50AX User’s Guide
174
Fig ure 104 Maintenance > File Manager > Firmware Package
The following table describes the labels in this screen.
After you see the Firm wa re Uploa d in Pro c e ss screen, wait two minutes before logging into the Zyxel
Device again.
Note: The Zyxel Device automatically reboots after a successful upload.
The Zyxel Device automatically restarts causing a temporary network disconnect. In some operating
systems, you may see the following icon on your desktop.
Fig ure 105 Network Temporarily Disconnected
After five minutes, log in again and check your new firmware version in the Da shbo a rd screen.
18.3.1 Exa m ple o f Firm wa re Uplo a d Using FTP
This procedure requires the Zyxel Device’s firmware. Download the firmware package from
www.zyxel.com and unzip it. The firmware file uses a .bin extension, for example, "600ABFH0C0.bin". Do
the following after you have obtained the firmware file.
1 Connect your computer to the Zyxel Device.
2 The FTP server IP address of the Zyxel Device in standalone mode is 192.168.1.2, so set your computer to
use a static IP address from 192.168.1.3 ~192.168.1.254.
Table 73 Maintenance > File Manager > Firmware Package
LABEL DESCRIPTIO N
Boot Module This is the version of the boot module that is currently on the Zyxel Device.
Current Version This is the firmware version and the date created.
Released Date This is the date that the version of the firmware was created.
File Path Type in the location of the file you want to upload in this field or click Bro wse ... to find it.
Browse... Click Bro wse ... to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click Uploa d to begin the upload process. This process may take up to two minutes.
To Next Page
Loading...
