Chapter 7 Setup Wizard
NWA50AX User’s Guide
52
7.2.4 Ste p 4 SSID
Use this screen to enable, disable or edit an SSID profile.
Select an SSID profile and click the Sta tus switch to turn it on or off. To change an SSID profile’s settings,
such as the SSID (WiFi network name) and WiFi password, double-click the SSID profile entry from the list.
See
Section 7.2.4.1 on page 52 for more information.
Note: You cannot add or remove an SSID profile after running the setup wizard.
Fig ure 26 Wizard: SSID
7.2.4.1 Edit SSID Pro file
Use this screen to configure an SSID profile.
The screen varies depending on the security type you selected.
• SSID: Enter a descriptive name of up to 32 printable characters for the wireless LAN.
• VLAN ID: Enter a VLAN ID for the Zyxel Device to use to tag traffic originating from this SSID.
Ba nd Mo de : Select the wireless band which this profile should use. 2.4 GHz is the frequency used by
IEEE 802.11b/g/n wireless clients. 5 GHz is the frequency used by IEEE 802.11ac/a/n wireless clients.
• Se c urity Typ e : Select WPA2 to add security on this wireless network. Otherwise, select O PEN to allow
any wireless client to associate this network without authentication.
• Pe rso na l: If you set Se c urity Type to WPA2 and select Pe rso na l, enter a pre-shared key of between 8
and 63 case-sensitive ASCII characters (including spaces and symbols) or 64 hexadecimal
characters.
Click OK to proceed. Click C a nc e l to close the screen without saving.
7.2.5 Sum ma ry
Use this screen to check whether what you have configured is correct. Click Sa ve to apply your settings
and complete the wizard setup. Otherwise, click Pre v to return to the previous screen or click Ca nc e l to
close the wizard without saving.
To Next Page
Loading...
