Chapter 20 LEDs
NWA50AX User’s Guide
181
Fig ure 110 Maintenance > LEDs > Suppression
The following table describes fields in the above screen.
20.3 Lo c a to r Sc re e n
The Locator feature identifies the location of your Zyxel Device among several devices in the network.
You can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn O n button to have the Zyxel Device
find its location. The Locator LED will start to blink for the number of minutes set in the Lo c a tor screen. The
default setting is 10 minutes. While the locator is running, the turn on button will gray out and return after
it’s finished. If you make changes to the time default setting, it will be stored as the default when the
Zyxel Device restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Ma inte na nc e > LEDs > Lo c a to r.
Table 76 Maintenance > LED > Suppression
LABEL DESCRIPTIO N
Suppression On If the Suppre ssion O n check box is checked, the LEDs of your Zyxel Device will turn off after
it’s ready.
If the check box is unchecked, the LEDs will stay lit after the Zyxel Device is ready.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Re se t to return the screen to its last-saved settings.
To Next Page
Loading...
