ZyXEL Communications NWA50AX - Page 70

Chapter 9 Network
NWA50AX User’s Guide
70
Fig ure 39 Configuration > Network > IP Setting
Each field is described in the following table.
Table 25 Configuration > Network > IP Setting
LABEL DESCRIPTIO N
IP Address Assignment
Get
Automatically
Select this to make the interface a DHCP client and automatically get the IP address,
subnet mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address Enter the IP address for this interface.
Subnet Mask Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Gateway Enter the IP address of the gateway. The Zyxel Device sends packets to the gateway when
it does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
DNS Server IP
Address
Enter the IP address of the DNS server.
IPv6 Address Assignment
Enable Stateless
Address Auto-
configuration
(SLAAC)
Select this to enable IPv6 stateless auto-configuration on the Zyxel Device. The Zyxel Device
will generate an IPv6 address itself from a prefix obtained from an IPv6 router in the network.
Link-Local
Address
This displays the IPv6 link-local address and the network prefix that the Zyxel Device
generates itself for the LAN interface.