Chapter 17 Log and Report
NWA50AX User’s Guide
165
Fig ure 101 Active Log Summary
This screen provides a different view and a different way of indicating which messages are included in
each log and each alert. (The De fa ult category includes debugging messages generated by open
source software.)
The following table describes the fields in this screen.
Table 70 Configuration > Log & Report > Log Setting > Active Log Summary
LABEL DESCRIPTIO N
Active Log
Summary
If the Zyxel Device is set to controller mode, the AC section controls logs generated by the
controller and the AP section controls logs generated by the managed APs.
System log Use the Syste m Lo g drop-down list to change the log settings for all of the log categories.
disa b le a ll log s (red X) - do not log any information for any category for the system log or e-mail
any logs to e-mail server 1 or 2.
e na b le no rma l log s (green check mark) - create log messages and alerts for all categories for
the system log. If e-mail server 1 or 2 also has normal logs enabled, the Zyxel Device will e-mail
logs to them.
e na b le no rma l log s a nd de bug lo g s (yellow check mark) - create log messages, alerts, and
debugging information for all categories. The Zyxel Device does not e-mail debugging
information, even if this setting is selected.
To Next Page
Loading...
