ZyXEL Communications NWA50AX - Page 29

Chapter 3 Hardware
NWA50AX User’s Guide
29
The following are the LED descriptions for your Zyxel Device.
Table 6 Zyxel Device LED
C O LO R STATUS DESCRIPTION
Amber Blinks amber for 1 second
and green for 1 second
alternatively.
The Zyxel Device is booting up or is connecting with NCC.
Green
Amber Blinks amber and green
alternatively 3 times and
then turns solid green for 3
seconds.
The Zyxel Device is discovering the NCC or an AC.
Green
Amber Blinks amber and green
alternatively 2 times and
then turns solid green for 3
seconds.
The Zyxel Device is managed by an AC but the uplink is
disconnected.
Green
Green Slow Blinking (On for 1
second, Off for 1 second)
The wireless module of the Zyxel Device is disabled or fails, the
Zyxel Device is using default wireless settings, or the Zyxel
Device is configured to be managed by NCC but is not yet
registered with the NCC.
Green Steady On The Zyxel Device is ready for use, the Zyxel Device’s wireless
interface is activated, and/or wireless clients are connected
to the Zyxel Device.
Bright Blue Steady On The Zyxel Device’s wireless interface is activated, but there
are no wireless clients connected.
Blue Slow Blinking (Blink for 1
time, Off for 1 second)
The Zyxel Device is performing a Channel Availability Check
(CAC) with Dynamic Frequency Selection (DFS) to monitor a
channel for radar signals.
Red On The Zyxel Device failed to boot up or is experiencing system
failure.
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
The Zyxel Device is undergoing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 seconds)
The Uplink port of the Zyxel Device in standalone mode is
disconnected.