Chapter 5 Standalone Configuration
NWA50AX User’s Guide
43
The Zyxel Device does not stop or start the system processes when you apply configuration files or run
shell scripts although you may temporarily lose access to network resources.
Using the RESET button If you press the RESET button on the back of the Zyxel Device, the Zyxel Device sets the
configuration to its default values and then reboots. See
Section 26.6 on page 205 for
more information.
Clicking Ma inte na nc e
> Shutdo wn >
Shutdo wn or using the
shutdown command
Clicking Ma inte na nc e > Shutd o wn > Shutdo wn or using the shutdown command writes all
cached data to the local storage and stops the system processes. Wait for the Zyxel
Device to shut down and then manually turn off or remove the power. It does not turn off
the power.
Disconnecting the
power
Power off occurs when you turn off the power to the Zyxel Device. The Zyxel Device simply
turns off. It does not stop the system processes or write cached data to local storage.
Table 13 Starting and Stopping the Zyxel Device
METHO D DESCRIPTIO N
To Next Page
Loading...
