ZyXEL Communications P-662HW-D - Figure 56 Advanced LAN Setup; Table 29 LAN IP; Table 30 Advanced LAN Setup; Configuring Advanced LAN Setup

Chapter 6 LAN Setup
P-662H/HW-D Series User’s Guide
107
The following table describes the fields in this screen.
6.3.1 Configuring Advanced LAN Setup
Use this screen to edit your ZyXEL Device's advanced LAN settings. Click the Advanced
Setup button in the LAN IP screen. The screen appears as shown.
Figure 56 Advanced LAN Setup
The following table describes the labels in this screen.
Table 29 LAN IP
LABEL DESCRIPTION
TCP/IP
IP Address Enter the IP address of your ZyXEL Device in dotted decimal notation, for
example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask assigned to you by your ISP (if given).
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Advanced Setup Click this button to display the Advanced LAN Setup screen and edit more
details of your LAN setup.
Table 30 Advanced LAN Setup
LABEL DESCRIPTION
RIP & Multicast
Setup
RIP Direction Select the RIP direction from None, Both, In Only and Out Only.
RIP Version Select the RIP version from RIP-1, RIP-2B and RIP-2M.
Multicast IGMP (Internet Group Management Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both IGMP
version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.