ZyXEL Communications P-662HW-D - Automatically Assign a WPA Key; Manually Assign a WEP Key; Manually Assign a WPA-PSK Key; Figure 33 Manually Assign a WPA Key

Chapter 3 Wizard Setup for Internet Access
P-662H/HW-D Series User’s Guide
69
3.3.1 Automatically assign a WPA key
Choose Manually assign a WPA key in the Wireless LAN setup screen to allow the ZyXEL
Device to configure a PSK key for you based on the setup key you entered on the previous
Wireless LAN setup screen. This key acts like a password to ensure only those Wireless LAN
devices you authorize are configured by OTIST.
3.3.2 Manually assign a WPA-PSK key
Choose Manually assign a WPA-PSK key in the Wireless LAN setup screen to set up a Pre-
Shared Key.
Figure 33 Manually assign a WPA key
The following table describes the labels in this screen.
3.3.3 Manually assign a WEP key
Choose Manually assign a WEP key to setup WEP Encryption parameters.
Table 16 Manually assign a WPA key
LABEL DESCRIPTION
Pre-Shared
Key
Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure
wireless connection by configuring WPA in the wireless LAN screens. You need to
configure an authentication server to do this.
Back Click Back to display the previous screen.
Next Click Next to proceed to the next screen.
Exit Click Exit to close the wizard screen without saving.