Chapter 7 Wireless LAN
P-662H/HW-D Series User’s Guide
135
7.10.2 Multiple SSID Example
This example shows how to configure a guest wireless network with the following parameters.
setprivacy type
<0:NO 1:WEP64
2:WEP128 3:WEP256>
This command specifies the security mode for the guest wireless network.
Type one of the following:
0 to disable security on the guest wireless network,
1 to enable 64-bit WEP key encryption,
2 to enable 128-bit WEP key encryption,
3 256-bit WEP key encryption.
setprivacy wepkey
<1-4> <Key String>
This command allows you to create up to four WEP keys. Enter 1, 2, 3 or 4
to specify which WEP key you are creating followed by any 5, 13 or 29
characters (ASCII string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-
F") for a 64-bit, 128-bit or 256-bit WEP key respectively.
setprivacy
defaultkey <1-4>
This command specifies which WEP key guests have to configure on their
wireless clients to access the guest wireless network.
guest_autoOff <
<1:on, 0:off>
<Timeout (minutes),
0 for default>
This command enables or disables an automatic timeout feature of the
guest wireless network. If you enable this feature the guest wireless network
becomes disabled after the specified amount of time. You need to enter two
parameters.
Type 0 to disable the automatic timeout feature or type 1 to enable it, for the
next value enter the number of minutes that the guest wireless network
stays active. Enter a number from 0 to 30000. Entering 0 resets the value to
the default (60 minutes).
Note: This command is hidden. It doesn’t show up when you
type the
wlan mssid command.
show This command allows you to review your guest wireless network settings.
Table 47 Multiple SSID Commands
COMMAND DESCRIPTION
Table 48 Multiple SSID Example Configuration
PARAMETER VALUE
SSID guestnetwork
Security 64-bit WEP key encryption.
WEP key abcde
Other Intranet blocking is enabled, so that guests only have access to the Internet
and cannot access the local network.
To Next Page
Loading...
