ZyXEL Communications P-662HW-D - Configuring Telnet; Telnet; Figure 165 Telnet Configuration on a TCP;IP Network; Figure 166 Remote Management: Telnet

Chapter 21 Remote Management Configuration
P-662H/HW-D Series User’s Guide
294
21.3 Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 165 Telnet Configuration on a TCP/IP Network
21.4 Configuring Telnet
Use this screen to configure remote management via telnet. Click Advanced > Remote
MGMT > Telnet tab to display the screen as shown.
Figure 166 Remote Management: Telnet
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click Apply to save your settings back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 123 Remote Management: WWW
LABEL DESCRIPTION