ZyXEL Communications P-662HW-D - Figure 172 Enabling TR-069; Table 130 TR-069 Commands

Chapter 21 Remote Management Configuration
P-662H/HW-D Series User’s Guide
301
" In this example a.b.c.d is the IP address of CNM Access. You must change
this value to reflect your actual management server IP address or domain
name. See Table 130 on page 301for detailed descriptions of the commands.
Figure 172 Enabling TR-069
The following table gives a description of TR-069 commands.
ras> wan tr069 load
ras> wan tr069 acsUrl a.b.c.d
Auto-Configuration Server URL: http://a.b.c.d
ras> wan tr069 periodicEnable 1
ras> wan tr069 informInterval 2400
TR069 Informinterval 2400
ras> wan tr069 active 1
ras> wan tr069 save
Table 130 TR-069 Commands
ROOT
COMMAND OR
SUBDIRECTO
RY
COMMAND DESCRIPTION
wan tr069 All TR-069 related commands must be preceded by wan tr069.
load Start configuring TR-069 on your ZyXEL Device.
active [0:no/
1:yes]
Enable/disable TR-069 operation.
acsUrl <URL> Set the IP address or domain name of CNM Access.
username
[maxlength:15]
Username used to authenticate the device when making a
connection to CNM Access. This username is set up on the server
and must be provided by the CNM Access administrator.
password
[maxlength:15]
Password used to authenticate the device when making a
connection to CNM Access. This password is set up on the server
and must be provided by the CNM Access administrator.
periodicEnable
[0:Disable/
1:Enable]
Whether or not the device must periodically send information to
CNM Access. It is recommended to set this value to 1 in order for
the ZyXEL Device to send information to CNM Access.
informInterval
[sec]
The duration in seconds of the interval for which the device MUST
attempt to connect with CNM Access to send information and
check for configuration updates. Enter a value between 30 and
2147483647 seconds.
save Save the TR-069 settings to your ZyXEL Device.