Chapter 11 Firewall Configuration
P-662H/HW-D Series User’s Guide
172
11.4.1 LAN to WAN Rules
The default rule for LAN to WAN traffic is that all users on the LAN are allowed non-
restricted access to the WAN. When you configure a LAN to WAN rule, you in essence want
to limit some or all users from accessing certain services on the WAN. WAN to LAN Rules
The default rule for WAN to LAN traffic blocks all incoming connections (WAN to LAN). If
you wish to allow certain WAN users to have access to your LAN, you will need to create
custom rules to allow it.
11.4.2 Alerts
Alerts are reports on events, such as attacks, that you may want to know about right away. You
can choose to generate an alert when a rule is matched in the Edit Rule screen (see Figure 98
on page 176).
When an event generates an alert, a message can be immediately sent to an e-
mail account that you specify in the Log Settings screen. Refer to the chapter on logs for
details
11.5 General Firewall Policy
Click Security > Firewall to display the following screen. Use this screen to activate and edit
firewall settings.
Refer to Section 10.1 on page 157 for more information.
Figure 96 Firewall: General
To Next Page
Loading...
