ZyXEL Communications P-662HW-D - Configuring Port Forwarding; Figure 85 NAT Port Forwarding; Table 53 NAT Port Forwarding

Chapter 9 Network Address Translation (NAT) Screens
P-662H/HW-D Series User’s Guide
147
9.5 Configuring Port Forwarding
" The Port Forwarding screen is available only when you select SUA Only in
the NAT > General screen.
" If you do not assign a Default Server IP address, the ZyXEL Device discards
all packets received for ports that are not specified here or in the remote
management setup.
Click Network > NAT > Port Forwarding to open the following screen.
See Appendix F on page 423 for port numbers commonly used for particular services.
Figure 85 NAT Port Forwarding
The following table describes the fields in this screen.
Table 53 NAT Port Forwarding
LABEL DESCRIPTION
Default Server
Setup
Default Server In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If
you do not assign a Default Server IP address, the ZyXEL Device discards all
packets received for ports that are not specified here or in the remote
management setup.
Port Forwarding
Service Name Select a service from the drop-down list box.
Server IP
Address
Enter the IP address of the server for the specified service.
Add Click this button to add a rule to the table below.